Getting Started; Operation - Hama Black Line Plus Operating Instructions Manual

Warning – Batteries
• Avoid storing, charging and using in extreme
temperatures and at extremely low atmospheric
pressures (such as at high altitudes).
• Ensure that batteries with damaged
housings do not come into contact
with water.
• Keep batteries out of the reach of
children.

4. Getting Started

Note
Please remember, during commissioning, to always
insert the batteries into the outdoor sensor rst and
then into the base station.
4.1 Insert batteries / connect power supply
Outdoor sensor
• Remove the screen protector from the display.
• Open the battery compartment and remove the contact
breaker.
• Then close the battery compartment cover.
Base station
Warning
• Connect the product only to a socket that has been
approved for the device. The socket must be installed
close to the product and must be easily accessible.
• When using a multi-socket power strip, make sure
that the sum power draw of all the connected devices
does not exceed its maximum throughput rating.
• If you will not be using the product for a long period
of time, disconnect it from mains power.
• Remove the screen protector from the display.
• Connect the power supply unit to the power supply unit
connection socket (G) on the back of the base station.
• Connect the weather station's power supply unit to a
correctly installed mains socket.
• Alternatively, open the battery compartment (H), insert
three AA batteries with the correct polarity and close
the battery compartment cover.
Note
If the batteries are inserted correctly and you connect
the power supply unit to the station, the base station
will automatically switch to the external power supply.

5. Operation

Note – Input
• Hold the button (B) or the
select the values faster.
• After the batteries are inserted, the base station
automatically searches for a connection to the outdoor
sensor and carries out the initial setup routine.
Note
• Initial setup takes approximately 3 minutes.
• During the connection attempt, the radio signal on
the outdoor sensor (9) ashes.
• Do not press any buttons during setup. Otherwise,
values may not be transmitted correctly and there is a
risk of value errors and inaccuracies.
• The setup process is completed when the indoor
and outdoor measurement data (15/21/26/28) is
displayed.
• If no signal is received from the outdoor sensor on a
repeated basis, press and hold the
3 seconds to start the manual search for the signal.
Note – Faulty transfer of measured
values
• In some cases, interference caused by a WiFi network,
computer, TV, etc., for example, may cause the
transmission of measurement values between the
base station and the outdoor sensor to fail.
button (C) to
key (E) for approx.
4