Getting Started - Hama Magic Color Operating Instruction

8. [SNOOZE-LIGHT]
- Press the top of the main unit to activate
[SNOOZE-LIGHT] button to turn on backlight
for 10 seconds. Meanwhile, the mood light
will be light up for 10 seconds if the main
unit is connecting with the DC adaptor and the
[MANUAL-MOOD-ALERT] slide switch is in the
MANUAL position.
- Stop alarm sound temporary for 5 minutes
when alarm sounds.
Note: When the clock is beeping, pressing any
button will stop it except the [SNOOZE- LIGHT]
button.
BATTERY INSTALLATION FOR MAIN UNIT
1. Remove the battery door.
2. Insert 3 pieces AAA size 1.5V alkaline battery
as indicate by the polarity;
3. Close the battery door.
Note: Replace the batteries when the low
battery indicator appears on the top-middle of
the lower LCD.
BATTERY INSTALLATION FOR REMOTE SENSOR
1. Remove the battery door.
2. Insert 2 pieces AAA size 1.5V alkaline battery
as indicate by the polarity;
3. Close the battery door.
Note: Replace the batteries when the low
battery indicator in each channel appears on
the top-left of the upper LCD.

GETTING STARTED

This In-Out thermo mood-light clock was
designed for easy set up. For best operation, the
following steps are required to be done in the
proper sequence.
1. Insert batteries to the main unit, it will
automatically search the remote sensors
(while they are in effective transmission
range) for 2 minutes and then receive RCC
signal for 10 minutes.
12
00092658bda.indd Abs1:12 00092658bda.indd Abs1:12
Note: Main unit can't be programmed
manually during RF searching and RCC
reception.
2. Insert batteries to the remote sensor and set it
to desired channel by pressing [CH] button.
3. The main unit will show the temperature
reading of the remote sensor in corresponding
channel if it receives the RF signal and
registers the remote sensor successfully.
4. Position the remote unit and main unit within
effective transmission range, which is, in
usual circumstances, is 30 meters (100 feet).
The remote sensor should be placed away
from direct sunlight, rain or snow.
WIRELESS REMOTE SENSOR REGISTRATION
PROCEDURE
Within 2 minutes of power up the main unit,
activates the sensor as follows:
1. Insert the 2 AAA batteries into the sensor unit
while the ' ' icon in the main unit is fl ashing
to prompt the user that the main unit is in
sensor searching mode.
2. The LED on the front panel of the sensor will
start fl ashing at a rate of one time per around
2 seconds to indicate channel 1 is in use.
While the LED is fl ashing, press once the [CH]
key will change the sensor channel setting to
2. Keep toggle on [CH] key can change
channel setting up to 3. The LED is blinking at
a frequency to indicate the channel setting. i.e.
continuous blinking 2 times indicates channel
2 is selected.
If no key entry for 10 seconds, it will exit the
channel setting mode and transmit the RF
signal of the temperature reading.
3. The main unit will show the temperature
reading of the remote sensor in corresponding
channel if it receives the RF signal and
registers the remote sensor successfully.
25.11.09 09:14 25.11.09 09:14