Xerox 2101 Customer Release Notes page 3

9. Set the Booklet Back Cover Mode option.
Does not force any back cover mode. The front cover is printed according to
AutoSelect:
Booklet Front Cover Mode, and the remaining pages of the document are printed in order
after that, with no blank pages in between. Depending on where the last pages of the
document fall, the back cover may be printed on both sides, printed on the front side only,
or blank.
Prints the last page of the document on the front of the back cover.
Print On Front Only:
Prints the last page of the document on the back of the back cover.
Print On Back Only:
Prints the last two pages of the document on the front and back of the back
Print Both:
cover.
Leaves the back cover blank on both sides.
Blank:
For all Booklet Back Cover Mode settings except for AutoSelect, blank pages may be
inserted at the end of the booklet's content, depending on the number of pages in the
document. For example, if Booklet Back Cover Mode is set to Print Both, blank pages are
inserted before the last two pages of the document as needed to make the last two pages fall
on the back cover.
10. Set the Booklet Cover Source option.
Choose Auto Select to use any tray that matches the Booklet Cover Media and Booklet
Cover Media Color settings (see the following steps).
If you also set the Paper Source option (which specifies the paper source for the
N :
OTE
booklet's contents) to Auto Select, the booklet cover and its contents are printed from the
same tray. Make sure that either Booklet Cover Source or Paper Source is set to a specific
tray.
For a blank cover, choose Tray 2, Tray 3, Tray 4, or Tray 7.
For a printed cover, choose Tray 2, Tray 3, or Tray 4.
11. Set the Booklet Cover Media option.
Choose Normal or Heavyweight1A for Tray 2, Tray 3, or Tray 4.
Choose Heavyweight1B or Heavyweight2 for Tray 7.
If you select a weight other than Normal, be sure that you program a tray to that
N :
OTE
weight at the copier before submitting the job to print.
12. Set the Booklet Cover Media Color option.
Choose White, Green, Blue, Yellow, Buff, Goldenrod, Other 1 or Other 2.
If you select a color other than White, be sure that you program a tray to that color
N :
OTE
at the copier before submitting the job to print.
13. Set any other options necessary to print the booklet.
14. Click OK to close the Properties window, and then click OK to submit the job for printing.
Page 3