Download Print this page

F&F FW-TO1S1 Manual

1-channel controller for gates and wickets

Advertisement

Quick Links

FW-TO1S1
1-channel controller
for gates and wickets
Do not dispose of this device to thrash with other unsorted waste! In accordance
with the Waste Electrical and Electronic Equipment Act any household electro-waste
can be turned in free of charge and in any quan� ty to a collec� on point established for
this purpose, as well as to the store in the event of purchasing new equipment (as per
the old for new rule, regardless of brand). Electro-waste thrown in the trash or aban-
doned in the bosom of nature pose a threat to the environment and human health.
Description of the system
F&Wave is a family of wireless devices controlled by radio with a range of up to 100
meters*. The receivers are available in either a DIN-rail mounting version (housing
1S) or a ø60 flush-mounted version. The transmitters are available as handheld remo-
te controllers or as a flush-mounted version. The receivers relay control signals. The
device that receives a control signal from the transmitter will automatically send it
forward, which allows to increase the range of the remote control.
* Range of up to 100 meters in open space without any interfering factors. In building conditions and in the presence of
interference sources (power lines, transmitters, etc.) the actual range may be smaller.
F&F Filipowski L.P.
Konstantynowska 79/81, 95-200 Pabianice, PL
phone/fax (+48 42) 215 23 83 / (+48 42) 227 09 71
www.fif.com.pl; e-mail: biuro@fif.com.pl
- 1 -

Advertisement

loading

Summary of Contents for F&F FW-TO1S1

  • Page 1 Konstantynowska 79/81, 95-200 Pabianice, PL phone/fax (+48 42) 215 23 83 / (+48 42) 227 09 71 www.fif.com.pl; e-mail: biuro@fif.com.pl FW-TO1S1 1-channel controller for gates and wickets Do not dispose of this device to thrash with other unsorted waste! In accordance with the Waste Electrical and Electronic Equipment Act any household electro-waste can be turned in free of charge and in any quan�...
  • Page 2: Features Of The Module

    Installation of this device should be carried out by a qualified installer after re- ading this manual. Dismantling the casing of the device will automatically void the warranty. Before starting the assembly, make sure that the connecting wires are not live. Conditions of storage, transport and use affect the proper operation of the device.
  • Page 3 Device description Wiring diagram - 3 -...
  • Page 4: Load Capacity

    Local control input, triggered by applying voltage to terminals 1-2. Triggering the input causes the relay contact to close for the time Input the button is pressed. Attention! The control input does not work with illuminated buttons. Relay output - separated normally open contact (the contact closes when the local button or the button on the transmitter associated with the controller is pressed).
  • Page 5 Programming controller Press and hold the PROG button for approximately 2 seconds until the LED ① on the controller starts blinking slowly (cycle 0.5 s ON - 0.5 s OFF). Release the button – the controller will now enter pairing mode with the remote transmitters.
  • Page 6 Devices of the F&Wave system Battery transmitters Type Product Flood sensor FW-FS1 Remote control FW-KEY, FW-RC4, FW-RC10 FW-WS1, FW-WS2, FW-WS3 Wall button FW-WSO1, FW-WSO2, FW-WSO4 Flush-mounted box ø60 FW-RC5 AC transmitters Type Product FW-GS1, FW-GS2, FW-GS4 Flush-mounted box ø60 FW-RC4-AC Receivers Function Flush-mounted box ø60...
  • Page 7: Technical Data

    Technical data power supply 9÷30 V AC/DC control input 9÷30 V AC/DC contact separated 1×NO power consumption operating mode (relay on) 0.60 W standby 0.25 W output load capacity (AC-1) 8 A/250 V AC radio frequency 868 MHz maximum emitted frequency power 10 mW working temperature -25÷65°C...