Advertisement
Programming controller
Press and hold the PROG button for approximately 2 seconds until the LED
①
on the controller starts blinking slowly (cycle 0.5 s ON - 0.5 s OFF).
Release the button – the controller will now enter pairing mode with the
remote transmitters. This mode is also indicated by the LED light blinking in
②
a cycle of 0.5 s ON – 0.5 s OFF. The controller will now listen for commands
from the F&Wave transmitters - any transmitter detected here will be paired
with the controller.
Binding of a transmitter button to the receiver is signalled by a 1-second LED
③
switch on.
④
You can link the controller to multiple transmitters in one programming step.
⑤
To complete programming, briefly press the PROG button.
Reset settings
①
Press and hold down the PROG button.
Keep the button pressed for at least 10 seconds. After the first two seconds
the LED will start to blink slowly, after a few more it will go out and after a
②
few more it will start to blink rapidly. The fast blinking indicates entry into
the setting reset mode.
③
Release the button. The LED should blink rapidly all the time.
Press and hold the PROG button until the LED lights up permanently, then
④
release the button.
When this sequence is completed, all programmed transmitters will be dele-
⑤
ted from the controller's memory.
- 5 -
Advertisement
