Periodic Replacement Of Parts - Hitachi Zaxis 850LC-3 Operator's Manual

PERIODIC REPLACEMENT OF PARTS

To ensure safe operation, be sure to conduct periodic inspec-
tion of the machine. In addition, the parts listed below, if de-
fective, may pose serious safety/fire hazards. It is very difficult
to gauge the extent of deterioration, fatigue, or weakening of
the parts listed below simply by visual inspection alone. For
this reason, replace these parts at the intervals shown in the
table below. However, if any of these parts are found to be
defective, replace before starting operation, regardless of the
interval.
Also, when replacing hoses, check the clamps for deformation,
cracks, or other deterioration, and replace as necessary.
Be sure to perform periodic inspection of all hoses, as shown
below, and replace or retighten any defective parts found, as
necessary.
Consult your authorized dealer for correct replacement.
Engine
Base Machine
Hydraulic
System
Front-End
Attachment
Other
NOTE: Be sure to replace seals, such as O-rings and
gaskets, when replacing hoses.
MAINTENANCE
Periodic Replacement Parts
Fuel hose (Fuel tank to filter)
Fuel hose (Fuel tank to injection pump)
Heater hose (Heater to engine)
Pump suction hose
Pump delivery hose
Swing hose
Travel hose
Boom cylinder line hose
Arm cylinder line hose
Bucket cylinder line hose
Pilot hose
Seat belt
Every 2 years or Every 6000 hours
Every 2 years or Every 6000 hours
Every 2 years or Every 6000 hours
Every 2 years or Every 6000 hours
Every 2 years or Every 6000 hours
Every 2 years or Every 6000 hours
Every 2 years or Every 6000 hours
Every 2 years or Every 6000 hours
Every 2 years or Every 6000 hours
Every 2 years or Every 6000 hours
Every 2 years or Every 6000 hours
Every 3 years
7-5
Replacement
Intervals