Page 1
HDMI4X4 User Manual www.xantech.com - 1 -...
Page 2
• HDMI or DVI to HDMI cables are used to connect the inputs and the matrix output • Each display's inputs can be switched with the IR remote control or through RS232 The HDMI4X4 consists of: (1) 4x4 HDMI Matrix (4) HDMI 6 Cables (M-M)
READ THESE NOTES BEFORE INSTALLING OR OPERATING THE HDMI4X4 • You should connect all the cables and power supply prior to connecting power to the HDTV sources and 4x4 HDMI Matrix. • When powering the sources, the display needs to point to the source input.
DIP SWITCH GUIDELINES Inside the 4x4 HDMI Matrix is a bank of Dip Switches. Below is a table describing their functions. By default, all switches are set to the Off position. Dip Switch # Name Switching Delay On Board EDID IR Code Dip Switch IR Code Dip Switch Unused...
Page 5
IR CODES In the event of IR conflicts, please do the following: 1. Remove the battery cover from the back of the RMT16-IR remote. 2. Locate the Dip Switches above the batteries 3. Switch the Dip Switches on the RMT16-IR to any of the combinations pictured below. 4.
Page 8
TECHNOLOGY TERMINIATION Short form for Display Data Channel. It is a VESA standard for communication between a monitor and a video adapter. Using DDC, a monitor can inform the video card about its properties, such as maximum resolution and color depth. The video card can then use this information to ensure that the user is presented with valid options for configuring the display.