INTRODUCTION The 4X4 HDMI™ Matrix routes high defi nition video in multiple resolutions up to 1080p plus multichannel digital audio from any of the four HDMI™ sources to the displays. Four outputs gives you the choice of sending high defi nition audio and video signals up to four displays.
The 4X4 HDMI Matrix is fully HDCP compliant. VIDEO COMPATIBILITY NOTE An HDMI source connects to the HDMI4X4 Matrix Switcher with four input cables and four output cables. Output devices are examined to obtain an EDID, or a data record of the performance characteristics of the display de- vices.
RMT16-IR INSTALLATION Remove battery cover from the back of the RMT16-IR remote. Verify that DIP switches 1 & 2 are in the down (OFF) position. Insert the battery; hold the battery so that you can see the positive side facing up. The side that is not marked must be facing down. Test the RMT16-IR remote by pressing ONLY one button at a time.
Page 7
Xantech Splitter known as DIP (Dual In-Line Package) switches. To access the DIP switches, remove all screws from the bottom and sides of the Xantech unit’s metal chassis. Carefully slide the unit apart. The bank of 8 DIP switches is located on the main printed circuit board (PCB).
Page 8
SETTING EDID MODES USING THE DIP SWITCH BANK EDID Mode 0 (Switch 1=OFF Switch2=OFF Switch5=ON) -EDID is copied from the device connected to the fi rst active HDMI output port. - All features newer than HDMI 1.2 are cleared. EDID Mode 1 (Switch 1=ON Switch2=OFF Switch5=ON) -Same as Mode 0 and adds basic audio support.
Page 9
Resolving Infrared Code Confl icts In the event of IR confl icts, please do the following: Remove the battery cover from the back of the RMT16-IR remote. Locate the DIP Switches above the batteries. Switch the DIP Switches on the RMT16-IR to any of the combina- tions pictured below.