Advertisement
Go to
www.elotouch.com/support
to download user manual.
1
Remove the cable cover door to access the I/O connections.
2
Route the DC power cable through the hole in the bottom of the stand and connect it as shown.
Connect other I/O cables as needed (see back page). Make sure all cables route behind the
plastic clip at the bottom.
DC Power
3
Mount the system to a table (optional). Skip to step 6 if not mounting to a table.
Secure the mounting bracket to the table using appropriate screw type and length. Elo suggests M4
or #10 screw diameter. Alternately, use the included VHB to attach the bracket to the table.
Lower the system onto the bracket and slide it back, ensuring the bracket hooks engage with the slots
4
on the bottom of the system.
Clip
5
Secure the system to the bracket using the screw included in the accessory box.
Power on the system when installation is complete.
6
Advertisement
