Table of Contents
Advertisement
• Add mounting and connection provision for an optional GNSS module on board. When installed, the
GNSS module provides the 1pps signal without the need for an external GNSS appliance. An I
interface provides a way to access the serial port data on the GNSS, including configuration options.
Table 2
provides additional information on the E810-CQDA2T:
Table 2.
E810-CQDA2T Product Information
Product Description
Product Codes
Host Interface
Form Factor
Front Panel Connectors
Internal Connectors
Optional GNSS SKU
Synchronous Ethernet
Oscillator
Power
Operating Temperature
EMI
Manageability
1. Refer to
Section 2.3
for 1PPS and 10 MHz signaling requirements.
2. Refer to
Table 3
for GNSS antenna characteristics.
8
1588 PTP/SyncE/GNSS 100/25/10 GbE QSFP28 PCIe adapter
E810CQDA2TG1 (no GNSS)
E810CQDA2TGG1 (with GNSS)
PCIe 3.0x16 or PCIe 4.0x8/x16 (x16 connector)
Full-height, half-length PCIe card
2x QSFP28, 2x SMA (1PPS/10 MHz/25 MHz)
1x U.FL input + 1x U.FL output (1PPS/10 MHz) / 25MHz; GNSS mezzanine
Supports GPS, Galileo, GLONASS, BeiDou, QZSS
ITU-T G.8261, G.8262, G.8262.1, and G.8264 (ESMC) support
1 ppb vs. temperature, 4 hours holdover (±1.5 µs under ±5 °C T)
36 W typical, 50 W max power consumption (with Class 7 optics at 100G maximum traffic)
0-55 °C with required airflow (passive heat sink)
FCC Class A
NC-SI over MCTP (over PCIe/SMBus); EFI based iSCSI boot; EFI/legacy PXE boot support
®
Intel
Ethernet Network Adapter E810-CQDA2T
1
2
, 1x SMB (GNSS antenna)
User Guide
2
C
722960-002
Advertisement
Table of Contents
