Table of Contents
Advertisement
DINION 7100i IR
TCP metadata input
TCP port
The device can receive data from an external TCP sender, for example an ATM or POS device,
and store it as metadata. Select the port for TCP communication. Select Off to deactivate the
function.
Sender IP address
Enter a valid Sender IP address.
Syslog
Server IP address
Enter the appropriate IP address of the server.
Server port (0 = Off)
Enter the number of the server port.
Protocol
Select the appropriate protocol: UDP, TCP, or TLS.
LLDP power configuration
This section shows a breakdown of the power values configured for the device.
The Additional power wattage can be adjusted in the respective input field. The default value
is 0.0 W.
Click Set to apply the changes.
4.7.4
Network Management
SNMP
The camera supports two versions of Simple Network Management Protocol (SNMP) for
managing and monitoring network components, and can send SNMP messages (traps) to IP
addresses. The unit supports SNMP MIB II in the unified code.
Select either of the options that follow for the SNMP parameter:
–
–
If you select either of the SNMP version, but do not enter an SNMP host address, the camera
does not send messages (traps) automatically, but only replies to SNMP requests.
Select Off to deactivate the SNMP function.
1. SNMP host address / 2. SNMP host address
If you wish to send SNMP traps automatically, enter the IP addresses of one or two required
target units here.
SNMP v1 legacy
When you select SNMP v1 legacy in the field SNMP, the fields Write community and SNMP
traps appear.
Write community
Type the password for Write community to allow the exchange of data between connected
devices.
SNMP traps
You can select which traps are to be sent.
1.
2.
Bosch Security Systems B.V.
SNMP v1 legacy
SNMP v3
Click Select. A list is opened.
Click the checkboxes to select the required traps. All the checked traps will be sent.
User manual
Configuration | en
2023-06 | V02 | F.01U.390.686
49
Advertisement
Table of Contents
