Precautions For Reassembly - Kenwood NXR-1800 Service Manual

3.1.2 LCD ASSY disassembly procedure
(1) While pushing the hook part of MOUNTING in the direction
of the arrow, remove the MOUNTING as shown in the
figure.
MOUNTING
Hook part
(2) The LCD ASSY is fixed to the MOUNTING with double
sided tape.
Separate the LCD ASSY by pushing it from the hole in the
MOUNTING in the direction of the arrow using a rod-
shaped jig (about Ø6-Ø7).
Note:
Be careful when separating the LCD ASSY from the
MOUNTING as it may cause the glass to chip and the
FPC to be damaged.
3.2

Precautions for Reassembly

3.2.1 LCD ASSY reassembly procedure
(1) Attach the cushion to the MOUNTING. <1>
Cushion
<1>
MOUNTING
PANEL ASSY
LCD ASSY with cushion
Double sided tape
MOUNTING
(2) Pass the FPC of LCD ASSY through the hole in the
MOUNTING and then attach it to the MOUNTING. <2> <3>
LCD ASSY
<3>
Double sided tape
3.2.2 Attach the LCD ASSY with MOUNTING to the PANEL
ASSY
(1) Insert the hook part on the FPC side of the MOUNTING into
the hole in the PANEL ASSY. <4>
(2) Insert while pressing the hook part of the MOUNTING to
pass the mounting hole, and fix it to the PANEL ASSY. <5>
Mounting hole
<4>
LCD ASSY with MOUNTING
(3) Make sure that there is no gap between the hook part of the
MOUNTING and the hole of the PANEL ASSY and
MOUNTING is fixed to the PANEL ASSY.
(4) After attaching the PANEL ASSY to the chassis, form the
FPC as shown in the figure and connect it to the connector.
FPC
FPC
LCD ASSY with MOUNTING
<2>
FPC hole
<5>
Hook part
Check point
(No.RA094<Rev.002>)1-51