Table of Contents
Advertisement
en Troubleshooting
Fault
"E:38 / -25 / -26"
"E:10 / -00 / -10 /
-20"
"H:32"
"E:30 / -10" or
"E:35 / -10"
46
Cause and troubleshooting
Inlet opening of the rubber gasket is blocked.
Clean the inlet opening in the rubber gasket.
▶
→ Page 44
The pump for the intelligent dosing system is blocked.
Clean the detergent drawer. → Page 40
1.
If the fault persists, call customer service.
2.
→ Page 53
Note: Until the fault is rectified, you can deactivate the
intelligent dosing system and dose manually.
→ Page 24
The appliance has interrupted the spin cycle because
the laundry is unevenly distributed.
Redistribute the laundry in the drum.
▶
.
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Check the installation of the water inlet hose.
▶
→ Page 12
The filter in the water inflow is blocked.
Clean the filter in the water inflow.
▶
The water pressure is low.
Check whether the tap has sufficient water pres-
▶
sure.
The water level measuring system is defective.
With this error message, the appliance starts a drain-
ing process.
Wait approx. 5 minutes until the draining process
1.
ends.
Restart the appliance.
2.
If required, start the draining process again.
If the fault persists, call customer service.
3.
→ Page 53
The appliance is leaking.
Turn off the water tap.
1.
Call customer service. → Page 53
2.
Advertisement
Table of Contents
