Husqvarna 330iKP Operator's Manual page 15

6. The chain is correctly tensioned when it
does not sag from the underside of the bar,
but can still be turned easily by hand. Hold
up the bar tip and tighten the bar nuts with
the combination wrench.
7. When fitting a new chain, the chain tension
has to be checked frequently until the
chain is run-in. Check the chain tension
regularly. A correctly tensioned chain
ensures good cutting performance and
long life.
To assemble the loop handle
1. Attach the loop handle onto the shaft
between the arrows.
2. Move the spacer into the slot of the loop
handle.
3. Install the screw and the knob. Do not
tighten too much.
4. Adjust the loop handle to an applicable
position.
5. Tighten the knob.
To assemble the two-piece shaft
1. Turn the knob to loosen the coupling.
2113 - 004 - 03.11.2023
2. Align the tab of the cutting attachment (A)
with the notch of the coupling (B).
3. Carefully push the shaft into the coupling
until you hear a click.
4. Tighten the knob fully.
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen
the coupling.
2. Push and hold the button (C).
3. Hold tight to the end of the shaft that the
motor is attached to.
B
A
15