Table of Contents
Advertisement
en How it works
Fault
A message that
reads "Fill water
tank?" appears on
the display when the
appliance is in opera-
tion.
"Appliance heating
up" appears on the
display but the appli-
ance is not reaching
the selected temper-
ature.
When cooking with
steam, a lot of steam
is produced.
When cooking with
steam, a lot of steam
is produced and this
happens repeatedly.
Steam escaping from
ventilation slots dur-
ing cooking.
Home Connect is not
working properly.
16.2 Replacing defective LED lights
Defective LED lights may be replaced by the manu-
▶
facturer, their customer service or a qualified techni-
cian (electrician) only.
16.3 Replacing the door seal
If the cooking compartment's outer door seal is defect-
ive, you must replace the door seal. Replacement seals
for your appliance can be obtained from our after-sales
service. Specify the E number and FD number of your
appliance.
How it works
17 How it works
Here, you can find the ideal settings for various dishes
as well as the best accessories and cookware. We
have tailored these recommendations to your appli-
ance.
17.1 What is the best way to proceed?
WARNING ‒ Risk of scalding!
Hot steam may escape when you open the appliance
door. Steam may not be visible, depending on the tem-
perature.
When opening the door, do not stand too close to
▶
the appliance.
Open the appliance door carefully.
▶
Keep children at a safe distance.
▶
Tip
If you are using the appliance for the first time, proceed
in accordance with the following basic information:
¡ → "Safety", Page 2
¡ → "Saving energy", Page 4
24
Cause and troubleshooting
Water tank half full.
For longer operations, completely fill the water tank.
▶
Automatic calibration values are not optimal.
Restore the appliance's factory settings and repeat the procedure for initial configuration.
▶
a The next time you use the steam function at 100 °C, the calibration runs automatically.
This generates more steam.
The appliance is being automatically calibrated.
No action required.
Appliance unable to calibrate itself automatically if cooking times too short.
Restore the appliance's factory settings and repeat the calibration process.
▶
This is standard procedure.
No action required.
Different causes are possible.
Go to www.home-connect.com.
▶
Open the appliance door.
1.
Remove the old door seal.
2.
Push the new door seal in on one side of the cook-
3.
ing compartment and then work it in all the way
round.
The joint must be at the side.
Check that the seal is correctly fitted, especially in
4.
the corners.
¡ → "Condensation", Page 25
1.
Select a suitable food type from the food overview.
Tips
¡ Your appliance has programmed settings for a
selection of food types. If you want to be guided
by the appliance, use the programmed dishes
→ Page 13.
¡ If you do not find the exact food or application
that you want to cook or use, look for a similar
dish and use that as a reference.
Remove any accessories from the cooking compart-
2.
ment.
Select suitable cookware and accessories.
3.
Use the cookware and accessories listed in the re-
commended settings.
Only preheat the appliance if the recipe or the re-
4.
commended settings tell you to do so.
Use the recommended settings when configuring
5.
the appliance settings.
Advertisement
Table of Contents
