Table of Contents
Advertisement
en Basic operation
To select a function, press the function on the dis-
2.
play.
a Depending on the function, possible setting values
or other tiles are available for selection.
To go back to a setting if necessary, press
3.
To change the setting values, use the digital setting
4.
ring:
Swipe over the setting ring clockwise or anti-
‒
clockwise, as required.
Or press a specific position on the setting ring.
‒
Use
to confirm the setting.
5.
Press
to start the operation.
6.
If the operation is ended:
7.
If required, you can select other settings and re-
‒
start the operation.
When the food is ready, use
‒
pliance off.
Note: You can save your settings as "Favourites"
and use these again.
→ "Favourites", Page 14
8.6 Filling the water tank
The water tank is located next to the cooking compart-
ment. You will need to fill the water tank before starting
any operation that uses steam.
WARNING ‒ Risk of scalding!
Hot steam may escape when you open the appliance
door. Steam may not be visible, depending on the tem-
perature.
When opening the door, do not stand too close to
▶
the appliance.
Open the appliance door carefully.
▶
Keep children at a safe distance.
▶
The water in the evaporator dish is still hot even after
the appliance has been switched off.
Never empty the evaporator dish immediately after
▶
switching off the appliance.
Allow the appliance to cool down before cleaning.
▶
When you open the appliance door, hot water may flow
out of the appliance.
When opening the door, do not stand too close to
▶
the appliance.
Open the appliance door carefully.
▶
Keep children away from the appliance.
▶
If the evaporator dish overflows, do not pour more
▶
water into the water tank.
ATTENTION!
Using unsuitable liquids may damage the appliance.
Do not use any liquids other than water.
▶
Only use cold, fresh tap water, softened water or
▶
non-carbonated mineral water.
Requirement: The water hardness range is set cor-
rectly.
1.
Open the appliance door.
10
.
to switch the ap-
Remove the water tank from the tank recess.
2.
Open the tank cover.
3.
Fill the water tank with cold water up to the max.
4.
mark.
Close the tank lid.
5.
Insert the full water tank back into the tank recess.
6.
Check that the water tank is flush with the water
7.
tank recess.
Close the appliance door.
8.
Advertisement
Table of Contents
