Makita GRU07T Instruction Manual page 17

1. Clasp the hook on the shoulder harness to tool's
ring and hanger.
1
Fig.20
► 1. Ring 2. Hook 3. Hanger
2. Put on the shoulder harness on your left shoulder.
Adjust the shoulder harness to a comfortable working
position.
Fig.21
The shoulder harness features a means of quick
release. Simply squeeze the sides of the buckle while
holding the tool to release the tool from the shoulder
harness.
Fig.22
► 1. Buckle
3
2
1
Correct handling of the tool
WARNING:
right-hand side. Correct positioning of the tool allows
for maximum control and will reduce the risk of seri-
ous personal injury.
WARNING:
control of the tool at all times. Do not allow the
tool to be deflected toward you or anyone in the
work vicinity. Failure to keep control of the tool
could result in serious injury to the bystander and the
operator.
WARNING:
than 15m (50 ft) distance between operators when
two or more operators work in one area. Also,
arrange a person to observe the distance between
operators. If someone or an animal enters the
working area, immediately stop the operation.
CAUTION:
If the cutting tool accidentally
impacts a rock or hard object during operation,
stop the tool and inspect for any damage. If the
cutting tool is damaged, replace it immediately.
Use of a damaged cutting tool may result in serious
personal injury.
Correct positioning and handling allow optimum control
and reduce the risk of injury.
Fig.23
When using a nylon cutting head (bump & feed
type)
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To feed out the nylon cord, tap the cutting head against
the ground while rotating.
Fig.24
► 1. Most effective cutting area
17 ENGLISH
Always position the tool on your
Be extremely careful to maintain
To avoid accident, leave more
1