Chapter 10
Triggering
Triggering with an Analog Source
Analog
Input
Channels
START TRIG
E Series User Manual
Figure 10-1 shows a falling-edge trigger.
You can also program your DAQ device to perform an action in response to
a trigger from a digital source. This action can affect the following:
•
Analog input acquisitions
•
Analog output generation
•
Counter behavior
Some E Series devices can generate a trigger on an analog signal.
Figure 10-2 shows the analog trigger circuit.
+
PGIA
ADC
–
Mux
PFI 0/AI
You must specify a source and an analog trigger type. The source can be
either the PFI 0/AI START TRIG pin or an analog input channel. Refer to
the
Analog Trigger Types
5 V
Digital Trigger
Falling edge initiates acquisition
Figure 10-1. Falling-Edge Trigger
Analog Comparison
Analog
Event
Trigger
(Analog Trigger
Detection
Circuitry Output)
Figure 10-2. Analog Trigger Circuit
section for more information.
10-2
0 V
AI Circuitry
AO Circuitry
Counter Circuitry
ni.com