Table of Contents
Advertisement
Accessory
BNC-2111
BNC-2115
BNC-2120
BNC-2090
CA-1000 enclosure
TB-2705
SCB-100
SCB-68
TBX-68
CB-68LP, CB-68LPR
Signal Source and Demo Accessory
Custom Cabling
© National Instruments Corporation
Table 1-3. E Series DAQ Accessories Overview (Continued)
BNC accessory for 68- or 100-pin E Series devices
BNC accessory for extended I/O on 100-pin E Series
devices
BNC accessory with function generator
(for 68-pin E Series devices)
Rack-mountable BNC accessory (for 68-pin E Series
devices)
Configurable connectivity enclosure
Latching screw terminal block for PXI E Series modules
100-pin, shielded screw terminal block with breadboard
areas
68-pin, shielded screw terminal block with breadboard
areas
68-pin, DIN rail-mountable screw terminal block
68-pin, low-cost screw terminal block
DAQ signal accessory to demo and test analog, digital,
and counter/timer functions
NI offers a variety of cables and accessories to help you prototype your
application or to use if you frequently change device interconnections.
However, if you want to develop your own cable, adhere to the following
guidelines for best results.
•
Use shielded twisted-pair wires for each differential AI pair. Connect
the shield for each signal pair to the ground reference at the source.
•
Route the analog lines separately from the digital lines.
•
When using a cable shield, use separate shields for the analog and
digital halves of the cable. Failure to do so results in noise coupling
into the analog signals from transient digital signals.
Mating connectors and a back-shell kit for making custom 68-pin cables
are available from NI. For more information about the 68- and 100-pin
Description
1-9
Chapter 1
DAQ System Overview
E Series User Manual
Advertisement
Table of Contents
