Advertisement
3. ASSEMBLY
Cutter Assembly
1. The install/remove cutter
A. Raise up the drill motor to its highest position.
B. Ensure grub screws are loosened.
C. Insert cutter into drill spindle with the two flats of the cutter aligned with grub
screws (Fig No.4 & 5). Make sure the center pin is inserted into
the cutter.
NOTE : Cutter should be fully placed into drill spindle.
C. Tighten set screws with M4 Allen key provided.
D. Reverse procedure to remove cutter.
!
2
3
Advertisement
