Yamaha MusicCast 200 Owner's Manual page 48

Network
Problem
Cannot configure connection using the
MusicCast Controller app.
The MusicCast Controller app does not
recognize the unit.
The network feature does not function.
Files on the media server (computer or NAS) are
not displayed (do not play).
The MusicCast Controller app does not
recognize the media server (computer or NAS).
Cause
The mobile device is not connected to the wireless LAN router
(access point).
The unit is in standby mode.
The unit and the mobile device are not on the same network.
A wireless LAN router that supports multiple SSIDs is used.
Network information (IP address) has not been properly obtained. Enable the DHCP server function on the router.
The unit is starting up (a period of approx. 30 seconds after the
power cord is plugged into an electrical outlet).
An IPv6-only router is being used.
The file format is not supported by the unit or the media server.
Media server sharing settings are not correct.
Security software installed on your media server is blocking access
by the unit.
The unit and the media server are not connected to the same
network.
48
Solution
Connect the mobile device to the wireless LAN router, and then
use MusicCast Controller to configure connection settings.
Turn on the unit.
Confirm network connections and wireless LAN router settings,
and then connect the unit and mobile device to the same
network.
The router's network splitter may be blocking access to the unit.
When connecting a mobile device, use an SSID that is able to
access to the unit. Try connecting to the primary SSID.
Do not attempt to operate the unit until start-up is complete.
Use an IPv4-compatible router.
Be sure to use a file format that is supported by both the unit and
the media server. For information on music files supported by this
unit, see "Devices/media, and file formats supported by the unit"
( p. 55).
Configure sharing settings to allow the unit access to folders on
the media server ( p. 26).
Confirm settings for security software installed on the media
server or wireless LAN router.
Confirm network connections and wireless LAN router settings,
and then connect the unit and media server to the same network.
Troubleshooting