Sub-Zero 700TF Specifications page 12

Planning Information
Integrated Model 700TF( I )
U P P E R V A L E N C E D E T A I L
1
8
(3)
3
45
8
(1153)
TO
BOTTOM
OF
DOOR
PANEL
80*
(2032)
TO
FLOOR
FINISHED HEIGHT OF 80" (2032) IS TO TOP OF SUB-ZERO MOLDING
*
Dimensions in parentheses are in
millimeters unless otherwise specified.
D O O R P A N E L H E I G H T
The height of the door panel can grow beyond 45
(1153) and exceed the 80" (2032) overall height, as long as
you stay below the recommended door panel weight limit
of 40 lbs (18 kg).
The illustration below shows how the panel may grow and
what you need to consider doing to finish the area in back
of the door panel.
IMPORTANT NOTE: The valance you use to finish the area
behind the door panel must stay behind the front plane of
the finished molding as shown in the illustration.
IMPORTANT NOTE: The depth of each Integrated unit is
24" (610) from the front of the unit to its back. Your
design may necessitate moving the unit back, or cabinets
forward to achieve a flush fit. This will require a minimum
rough opening depth of 25" (635). Refer to the illustration.
1
1
2 (38)
DECORATIVE VALANCE
CANNOT EXTEND BEYOND
THE FRONT OF THIS PLANE
DECORATIVE VALANCE
REMOVABLE MOLDING
BY SUB-ZERO
25
TO WALL
(635)
TOP HINGE
3
/ "
8
12