Setup; Preparing The Machine - Toro Reelmaster 5610 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
Media and Additional Parts
Description
Operator's Manual
Engine owner's manual
Note:
Determine the left and right sides of the
machine from the normal operating position.
1

Preparing the Machine

No Parts Required
Procedure
1. Park the machine on a level surface, lower the
cutting units, and engage the parking brake.
2. Shut off the engine, remove the key, and wait for
all moving parts to stop.
3. Check the tire air pressure before use; refer to
Checking the Tire Air Pressure (page
Note:
The tires are overinflated for shipping.
Adjust the tire air pressure before operating the
machine.
Description
No parts required
No parts required
Right front hose guide
Left front hose guide
Rear weights (size varies with
configuration)
Hood lock, seal, and jam nut
Washer
Cutting-unit kickstand
CE decal
Production year decal
Warning decal
52).
Qty.
–
–
1
1
Varies
1
1
1
1
1
1
Qty.
1 Read the manual before operating the machine.
1 Read the manual before operating the engine.
4. Check the hydraulic-fluid level; refer to
the Hydraulic-Fluid Level (page
5. Grease the machine; refer to
Bearings and Bushings (page
Important:
machine will result in premature failure of
critical parts.
6. Open the hood and check the coolant level; refer
to Checking the Coolant Level (page
7. Check the level of the engine-oil level, and
close and latch the hood; refer to
Engine-Oil Level (page
Note:
crankcase; however, check the oil level before
and after the engine is first started.
10
Use
Prepare the machine.
Adjust the control-arm position.
Install the cutting units.
Install rear weights (order from your
Toro Distributor).
Install the CE hood lock.
Install the cutting-unit kickstand.
Apply the CE decals.
Use
Failure to properly grease the
44).
The engine ships with oil in the
Checking
58).
Greasing the
42).
54).
Checking the