Sub-Zero 650 Specifications page 10
Built-in model over-and-under refrigerator / freezer
Hide thumbs
Also See for Sub-Zero 650:
- Design manual (80 pages) ,
- Use & care information manual (40 pages) ,
- Use & care manual (40 pages)
Table of Contents
Advertisement
Planning Information
Built-In Model 650
O V E R L A Y P A N E L S
Overlay Panel
1 /4
"(6) Backer Panel
Spacer Panel
3"
(76)
1 /2
"
Bottom Edge –
(13)
Hinge Side
(rear view)
3 /8
"
(10)
Recessed area for hinge plate
Overlay Panel
Spacer Panel
Backer
Panel
5 /16
(8)
27 /32
"
17 /32
(21)
"
(13)
Reveal area for door panel
Dimensions in parentheses are in
millimeters unless otherwise specified.
O V E R L A Y P A N E L S
IMPORTANT NOTE: For overlay door panels, it is neces-
sary to rout a space for the unit's lower hinge plate so
that it does not strike the door panel. Refer to the top
illustration on this page.
You will minimize the reveal between the bottom of the
overlay door panel and the top of the overlay drawer panel.
Refer to the bottom illustration on this page.
If you choose not to rout a space for the lower hinge plate,
you can reduce the total height of the overlay panel (deco-
rative panel only) by
Do not exceed the overlay panel dimensions listed. If
you try to make the reveal tighter between the door
and drawer panels, the panels may hit when opening
and closing, causing possible damage to the panels and
the Sub-Zero unit.
"
1
/
" (13).
2
10
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Sub-Zero 650 and is the answer not in the manual?
Questions and answers
freezer basket wont go in
The freezer basket may not fit in the Sub-Zero 650 if the entire freezer drawer has not been properly removed before attempting to remove or install the baskets. For proper fit, the drawer must be fully opened, the upper basket pulled to the front, and the drawer lifted while pulling forward to remove it. Reinstallation requires reversing these steps. Improper removal or reinstallation can prevent the basket from fitting correctly.
This answer is automatically generated