Installation Notes - Sub-Zero 424 Specifications

Planning Information
Wine Storage Model 424
I N S T A L L A T I O N N O T E S
Refer to the illustrations and specifications
for overall dimensions, finished rough opening
dimensions and installation specifics.
The Wine Storage unit must be installed to
open a minimum of 90˚ or you will have
problems pulling the shelves out.
For corner installations, you need allow for a
minimum 3" (76) filler so the door can open to
90˚. If you are using some larger handle
hardware, you will also need to take that into
account.
If you are installing a wine unit next to an
existing Sub-Zero unit, you may have to allow
for a filler strip. Also, if there is 2" (51) or less in
between units, an optional heater kit will need
to be installed to prevent moisture from forming
in between units. The optional heater kit is avail-
able from your Sub-Zero dealer. To obtain local
dealer information, visit the Locator section of
our website, subzero.com.
If you are connecting the unit to your home
security system, you must allow a minimum of
36" (914) of the system's wiring to be routed in
the electrical area designated for your model.
The anti-tip bracket must be installed to
prevent the unit from tipping forward.
When planning to install the Model 424 next
to adjoining cabinetry, you must make provi-
sions to allow the door to open to a maximum
of 145˚ and not interfere with the door panel.
Refer to the full-scale illustration on page 11 for
cabinetry dimensions.
For the overlay design, you will need to
provide a door panel frame for the glass door.
Refer to pages 6–7 for complete panel
information.
Dimensions in parentheses are in
millimeters unless otherwise specified.
IMPORTANT NOTE: A solid door panel must
not be installed on a glass door unit, as this
may cause moisture to form behind the panel.
For overlay panel applications, you must
supply your own handle hardware. It is recom-
mended you use our optional handles and use
the pre-drilled holes supplied to locate the
handles within the frame of our unit. Refer to
page 8 for specifics about installing handle
hardware.
For Model 424, the weight limit for the door
panel frame is 10 lbs (5 kg).
Sub-Zero has provided a natural cherry wood
facing to each of the wine shelves. You can
choose to replace these strips with wood more
complementary to your design and surrounding
cabinetry. Refer to the full-scale illustration on
page 10 for dimensions on the wood facing.
A 115 V AC, 60 Hz, 15 amp fused electrical
supply is required. It is recommended that a
separate circuit, serving only this appliance, be
provided.
All Sub-Zero Wine Storage units are
equipped with a power supply cord with a
3-prong grounding plug which must be plugged
into a mating 3-prong grounding type wall
receptacle. Locate electrical within the shaded
area shown in the installation illustration on
page 4.
You must follow all National Electrical Code
regulations. In addition, be aware of local codes
and ordinances when installing your service.
Refer to the Wine Storage Installation Instruc-
tions packed with the appliance, which provides
step-by-step procedures for making sure the
unit is installed properly.
5