Huawei SUN2000-50KTL-M0 User Manual page 57

SUN2000-(50KTL, 60KTL, 65KTL)-M0
User Manual
Installing the AC Output Power Cable
Step 1 Remove the locking cap from the AC OUTPUT cable gland and then remove the
plug.
Step 2 Route the cable through the cable gland.
1. Select appropriate rubber fittings based on the outer diameter of the AC power
2. To avoid damaging the rubber fitting, do not route a cable with a crimped OT
3. Adjusting a cable when the thread-lock sealing nut is tightened will shift the
Figure 5-8 Routing a cable
Step 3 Remove an appropriate length of the jacket and insulation layer from the AC
output power cable using a wire stripper.
Ensure that the jacket is in the maintenance compartment.
Figure 5-9 Three-core cable (excluding the ground cable and neutral wire)
(A) Core wire
Issue 11 (2024-02-02)
NO TICE
cable to ensure proper sealing.
terminal directly through the rubber fitting.
rubber fitting, which will affect the Ingress Protection Rating of the device.
NO TICE
Copyright © Huawei Technologies Co., Ltd.
(B) Insulation layer
5 Electrical Connections
(C) Jacket
49