Table of Contents
Advertisement
96
Homelink
®
12. Press and release the learn button on the
garage door opener motor.
• Note: once the button is pressed, there are
30 seconds in which to initiate the next
step.
13 . On the Homel ink® keypad inside the vehi-
cle, firmly press and hold the Homelink ®
button previously programmed in phases
1 and 2 for two seconds and release. Re-
peat t his sequence twice.
• Some vehicles may require the press/hold/
release sequence up to t hree times to com-
plete the training process.
• HomeLink ® should now activate your rolling
code equipped device.
If the
5
minute time limit is exceeded, the
emergency flashers will flash one time to in-
d icate that the process has been terminated.
In t his case, repeat steps 4 through 9 .
If the emergency flashers do not flas h
three
times (after about 15-60 seconds), program-
ming was not successful. In this case, repeat
steps 4 through 9.
Remote control units for garage door openers
in Canada are set to stop transmitting radio
frequency signals after two seconds. This time
may not be sufficient for the Homelink ® sys-
tem to learn the radio frequency s ignal. Per-
form all other steps as described above .
Operating the Homelink ® transmitter
The HomeLink ® transmitter works in the
same manner as the original handheld re-
mote control that came with the system .
Fig. 106
Overhead console: Homelin k® keypad
• Press the appropr iate programmed button
(D,
® or @ to activate the desired remote
contro l function
~
A
in General informa-
tion on page 94.
Reprogramming a single button
A HomeLink ® button can be reprogrammed
individually without affecting the other but-
ton allocations.
Programming the overhead keypad
• Press the appropriate Homelink ® button un-
til the indicator light begins flashing slowly.
Programming the bumper mounted trans
mitter
1.
Hold the
original remote control
at a dis-
tance between 0-5 in. (0-13 cm) from the
bumper below the appropriate headlight
for your vehicle (use the shortest distance
possible) .
2. Aim the remote control just below the
driver side headlight .
3 . Press and hold the act ivation button on
the remote control.
4. The emerge ncy flashers will flash three
times (after about 15-60 seconds) when
the programming is successful. Now re-
lease the button on the remote control.
• If the device utilizes a rolling code, please
follow phase 3 of
c:>
page 95, Programming
the HomeLink ® transmitter
for rolling code
programm ing .
This procedure will cause the existing pro-
gramming on the Homelink ® button to be
erased!
Erasing the programming of the
Homelink ® transmitter
When you erase the programming, the pro-
gramming on all three of the transmitter
channels with be lost!
.,. Perform steps 1 to 4 as described on
c:>
page 95, Phase 1: programming the over-
head keypad .
..,.
Advertisement
Table of Contents
