Table of Contents
Advertisement
Programming the Homelink ®
transmitter
The transmitter is programmed in two phas-
es. For rolling code transmitters, a third
phase is also necessary.
Fig. 104 Overhead console: Homelink ® keypad
Fig. 105 Front bumper, driver side: location of trans -
mitte r unit
Phase 1:
programming the overhead keypad
1. Make sure your vehicle is w ith in operat ing
range of the remote controlled ga rage
door opener .
2. Set the parking brake ~ &.
in General in-
formation on page 94.
3. Turn the ignition on . Do not start the en-
g ine!
4 . Press and hold the two outside Home-
Link® buttons
(D
and @ for approxi-
mately 20 seconds until indicator light @
~
fig. 104
begins to flash . Then release
both buttons . Do not hold the buttons for
longer than 30 seconds.
.. This procedure only needs to be performed
once.
It erases the factory-set default codes
and does not have to be repeated to pro-
gram additional remote contro ls .
Homelin
k®
95
5. Press and ho ld the Homelink ® button
(D,
@ or §
until the indicator light @
starts flashing
slowly .
Release the button.
.. The system will remain in programming
mode for 5 minutes.
Go
to the front of the
vehicle and proceed with phase 2 .
Phase 2:
programming the bumper mounted trans
mitter
6. Hold the
original remote control
at a d is-
tance between 0- 6 in. (0- 15 cm) from the
bumper below the appropr iate headlight
for your vehicleQ
fig. 105
(use the short-
est distance possible) .
7. Aim the remote control just below the
driver side
headligh t.
8. Press and hold the activation button on
the remote control.
.. May be different in Canada . If so, press and
re-press (cycle) the activation button on your
remote control every two seconds .
9. The emergency flashers will flash
three
times
(after about 15 - 60 seconds) when
the programming is successful. Release
the button on the remote control.
.. To program more devices, repeat steps 4 to
9.
10. Press and hold the trained Homelink ®
button and observe the indicator light @
Q fig.
104.
.. If the indicator light is solid/continuous,
programm ing is complete and your device
should activate when you press and release
the t rained Homelink ® button.
.. If the indicator light blinks rapidly for 2 sec -
onds and is then a solid/continuous
light,
proceed with phase 3 to program a rolling
code device.
Phase 3: rolling code programming
.. A second person on a ladder who can safely
reach the garage door opener motor is rec -
ommended .
11. Locate the "learn" button on the garage
door opener motor (refer to the operating
instructions for the opener, as t he loca-
tion of this button may vary by manufac-
turer) .
Advertisement
Table of Contents
