Connecting Two Vcrs - Sony KPR-41EXR95 Operating Instructions Manual

Connecting Other Equipment
Connecting two VCRs (not equipped with an S video output jack) for tape editing
—<;: Signal flow
(Front inner panel)
o) (>) (2)
TS)
VMC-810/S820S
(not supplied)
Preparing for use
1. Tum on the projection TV.
2 Press TV/VIDEO on the projection TV or on the Remote
Commander so that "VIDEO 1," "VIDEO 2" or "VIDEO 3"
appears on the screen.
VIDEO 1: for equipment connected to VIDEO 1 IN
VIDEO 2: for equipment connected to VIDEO 2 IN
VIDEO 3: for equipment connected to VIDEO 3 IN
Notes
if you try to use equipment that is connected to the front and rear
VIDEO 3 IN jacks at the same time, the picture will be distorted.
Be sure you tum off one piece of equipment first.
If you have connected to a Camcorder's input jacks, do not
connect to the projection TV's input jacks.
If you connect equipment to the rear VIDEO 3 IN S VIDEO jack,
you cannot receive the output signal from the VIDEO 3 OUT
VIDEO jack.
1 8 | Chapter 1: Setting Up
(Rear of projection TV)
to audio |.) [I
output 4
VCR
(for recording)
VMC-810/S820S
(not supplied)
Watching a different image while duplicating
The VIDEO 3 OUT jacks only output the signal from the
VIDEO 3 input jacks.
If you connect a VCR for playback to the front or rear VIDEO
3 IN jacks, and a VCR for recording to the VIDEO 3 OUT
jacks to duplicate your recorded tapes, you can watch input
images different from the image being output for recording.
To watch a different input image
Press TV/VIDEO on the projection TV or on the Remote
Commander to select the input image you want to watch.