Making Antenna Connections - Sony KPR-41EXR95 Operating Instructions Manual

Making Antenna Connections
Although you can use either an indoor or outdoor antenna with the projection TV, an outdoor antenna will
provide you with better picture quality.
You can receive cable TV by connecting a cable supplied by your local cable company.
Connecting a VHF, UHF or VHF/UHF combination antenna . , or CATV cable
Check your antenna cable type. If you have 75-ohm coaxial cable (round), attach an F-type connector (not
supplied). If you have 300-ohm twin-lead cable (flat), attach a 300-75 ohm adaptor (not supplied).
Using 75-ohm coaxial cable (round) Using 300-ohm twin-lead cable (flat)
Prepare the end of the cable by attaching the F-type Prepare the end of the cable by attaching the 300-75
connector as shown below. ohm adaptor as shown below.
300-75 ohm aeiee
Loosen with or ae
a screwdriver. =o
-*) Se
rt]
p
Attach the 5
cable and 3S a
fasten with a s s
screwdriver. Fs
|
Plug the connector into the VHF/UHF terminal at the Plug the adaptor into the VHF/UHF terminal at the rear
rear of the projection TV. of the projection TV.
(Rear of projection TV)
(Rear of projection TV)
VHF/UHF
* Most combination antennas are equipped with a signal splitter.
Remove the splitter and attach the appropriate connector.
Chapter 1; Setting Up | 13