Connecting Two Vcrs For Tape Editing - Sony KP 48S70 Operating Instructions Manual

Installing and Connecting the Projection TV (continued)
Connecting two VCRs for tape
editing
By connecting a second VCR to MONITOR
OUT, you can record a program being played
by the primary VCR to the second VCR or
perform tape editing and dubbing.
1
Connect the VCR intended for playback
using the connection instructions on page
6 of this manual.
2
Using an AUDIO/VIDEO cable, connect
AUDIO and VIDEO IN on the VCR
intended for recording to AUDIO and
VIDEO OUT of MONITOR OUT on the
projection TV.
Notes:
• Do not change the input signal while
editing through MONITOR OUT.
• When connecting a single VCR to the
projection TV: if VCR LINE OUT is
connected to VIDEO IN on the projection
TV, do not connect MONITOR OUT on
the projection TV to the VCR LINE
INPUT (see right). Doing so will cause
program interference and other viewing
problems.
10
Disconnect all power sources before making any connections.
VCR (for playback)
AUDIO R AUDIO L VIDEO OUT
LINE
OUT IN
VIDEO
AUDIO-L
AUDIO-R
1
VMC-810S/820S
(not supplied)
(Rear of projectionTV)
VIDEO IN
VCR
(Rear of projection TV)
CONVERTER
IN
VIDEO 1 VIDEO 3
VHF/UHF
OUT
S VIDEO MONITOR AUDIO
(VAR/FIX)
VIDEO Y VIDEO
L
L
P
B
(MONO)
(MONO)
AUDIO AUDIO
P
R R R
COMPONENT
VIDEO
AUDIO-L
AUDIO-R
VMC-810S/820S
(not supplied)
MONITOR
OUT
Indicates direction
of signal
LINE
IN OUT
AUX
TO
VCR (for recording)
AUDIO R AUDIO L VIDEO OUT
LINE
IN IN
2