Table of Contents
Advertisement
Connecting two VCRs (equipped with an S video output jack) for tape editing
<>:
Signal flow
YC-15V/30V
4
(not supplied)
VCR
(for playback)
|
Preparing for use/Operating the equipment
Same as p. 15.
Note
Do not change the input signal while editing through MONITOR
OUT, or the output signal will also change.
* {tis not necessary to connect to the MONITOR OUT S VIDEO
jack to receive the S video input signal. You can make the
connection as shown above, or connect the MONITOR OUT
jacks to the VCR for recording, using the VMC-810S/820S
connector (not supplied).
(Rear of projection TV)
MONITOR OUT
owe
S VIDEO+
YC-15V/30V
(not supplied)
woudnby
sep
Gupsouueg
(for recording)
Caution
Video tapes and other materials may be copyrighted.
Unauthorized recording of such materia! may be contrary
to the provisions of the copyright laws.
About the CONTROL S jacks
Make the following connections to contro! the projection TV
and connected equipment with one Remote Commander.
¢ Connect the equipment to CONTROL S IN to contro! the
projection TV with the other equipment's remote
commander.
© Connect the equipment to CONTROL S OUT to contro!
the other equipment with the projection TV's Remote
Commander.
Cap: Satna | 47
Advertisement
Table of Contents
