11.7. Configuring printer parameters
You can configure printer settings via the buttons on the printer or the printer software. The printer
settings you can configure via the buttons is limited.
To configure parameters via Windows® software, refer to Configuring printer with Windows®
Label Printer Utility.
11.7.1. Parameters configurable via buttons
The parameters are listed in the order that you will configure them.
COM Port setting
Baud rate
Printer setting
Paper Mode
Print Density
Protocol
11.7.2. Configuring parameters via buttons
Activating settings mode
To activate the settings mode, perform the following steps within 2 seconds after powering the
printer on:
1. Press the power button
2. Press the feed button
Configuring parameters
The printer will print a label with every parameter you configure.
Refer to Parameters configurable via buttons for parameters you can configure.
◼
Press the power button
◼
Press the feed button
Exiting settings mode
1. To exit settings mode, switch the printer off.
9600
19200
38400
57600
115200
label
black mark
auto
receipt
0 - 14
ESC
TSPL
three times.
one time.
to select a setting.
to confirm a setting and move to the next setting item.
17