Sony Handycam DCR-HC20 Operation Manual page 70

4 Touch _ (pause) again at the point
where you want to start recording the
sound.
The playback pauses.
Touch [_ and select [PAGE3I.
6
Touch [A DUB CTRL].
7 Touch [AUDIO DUBI.
A green w, n mark appears on |he LCD
screen.
Touch EN
(play) and start playing
back the audio you want to record at
the same time.
A red _ mark remains on the LCD screen
while recording sound.
The new sound is recorded in stereo 2
([ST2]) during 1he pl3yback of_he tape.
Touch [_
(stop) when you want to
stop recording.
To dub on other scenes, repeat steps 3 and 4
to select scenes, 1hen touch [AUDIO DUB].
10Toueh [ _ RE'r.I, then [_D.
To set the end point for audio dubbing
During playback, press ZERO SET MEMORY
on the Remote Commander at _he scene at
which you want to stop audio dubbing. Then,
pertbnn steps 4 to 8. The recording stops
automatically at the selected scene.
O
Note
• You can only _cord additional audio over a tape
recorded on your camco_er. The gound may
detedora_ when you dub audio on a tape recorded
on other camcorders (including other DCR-HC20
camco_er_.
Play back the tape on which you have
recorded audio in "Recording sound"
(p. 69).
Touch [_ to display [PAGE1].
Touch MENU.
Select _ (VCR SE'D, then select
[AUDIOMIX]with E_llED,then
touch [EXECI.
vc_ SET
Touch _ / _ to adjust the
balance between the original sound
([ST1]) and the sound added
afterwards ([ST2]). Then, touch
[EXECI.
The original sound ([STI]) is output in the
default setting.
The 3diusled audio balance returns to the
default selting in about 5 minutes after the
battery pack or other power sources have
been disconnected.
70 Dubbing/Editing