Table of Contents
Advertisement
Signal
Problem
10 blinks
The burner does not
switch on, and the lock-
out appears
The burner goes into
lockout
No blink
The burner does not
start
The burner continues to
repeat the start-up cy-
cle, without lockout
Ignition with pulsations
Burner does not reach
maximum output
Burner stops with air
damper open
Faults - Probable causes - Solutions
Possible cause
Incorrect electrical wiring
Defective flame control
Presence of electromagnetic disturbances in the
thermostat lines
Presence of electromagnetic disturbance
No electrical power supply
A limiter or safety control device is open
Line fuse blocked
Defective flame control
No gas supply
Mains gas pressure insufficient
Minimum gas pressure switch fails to close
Servomotor fails to move to min. ignition position Replace
The gas pressure in the gas mains lies very close
to the value to which the gas pressure switch has
been set. The sudden drop in pressure after valve
opening causes temporary opening of the pres-
sure switch itself, the valve immediately closes
and the burner comes to a halt. Pressure increas-
es again, the pressure switch closes again and the
ignition cycle is repeated. And so on
Poorly adjusted head
Ignition electrode incorrectly adjusted
Incorrectly adjusted fan air damper: too much air Adjust
Output during ignition phase is too high
Remote control device TR fails to close
Defective flame control
Defective servomotor
Defective servomotor
33
GB
Recommended remedy
Check
Replace
Filter or eliminate
Use the radio disturbance protec-
tion kit
Check connections
Adjust or replace
Replace
Replace
Open the manual valves between
contactor and train
Contact your gas company
Adjust or replace
Reduce the minimum gas pressure
switch intervention pressure. Re-
place the gas filter cartridge.
Adjust
Adjust it
Reduce
Adjust or replace
Replace
Replace
Replace
Tab. Q
20160598
Advertisement
Table of Contents
