Cable Connectors; Product Overview; Pin To 5-Pin Conversion Chart - Iridium Arc Bar Pro 1215 Manual

CABLE CONNECTORS

Product Overview

Cabling must have a male XLR connector on one end and a female XLR connector on
the other end.
DMX connector configuration
caution:Do not allow contact between the ground and the fixture's chassis ground. Grounding the
ground can cause a ground loop, and your fixture may perform erratically. Test cables with an ohm
meter to verify positive pole and to make sure the pins are not grounded or shorted to the shield or
each other.

3-PIN TO 5-PIN CONVERSION CHART

Note! If you use a controller with a 5 pin DMX output connector, you need to use a 5 pin
to 3 pin adapter. The chart below details a proper cable conversion:
Conductor
Ground/Shield
Data ( - ) signal
Data ( + ) signal
Do not use
Do not use
DMX-IN
GROUND
3-PIN TO 5-PIN CONVERSION CHART
3 Pin Female (output)
Pin 1
Pin 2
Pin 3
POWER-IN
5 Pin Male (Input)
Pin 1
Pin 2
Pin 3
Do not use
Do not use
MENU DOWN UP
21 1
ENTER
POWER-OUT DMX-OUT