Cable Connectors; Mechanical Specification - Iridium LED WASH PRO 44WS 44x20W Manual

CABLE CONNECTORS

Cabling must have a male XLR connector on one end and a female XLR connector on
the other end.
DMX connector configuration
GROUND
caution:Do not allow contact between the ground and the fixture's chassis ground. Grounding the
ground can cause a ground loop, and your fixture may perform erratically. Test cables with an ohm
meter to verify positive pole and to make sure the pins are not grounded or shorted to the shield or
each other.
3-PIN TO 5-PIN CONVERSION CHART
Note! If you use a controller with a 5 pin DMX output connector, you need to use a 5 pin
to 3 pin adapter. The chart below details a proper cable conversion:
3-PIN TO 5-PIN CONVERSION CHART
Conductor 3 Pin Female (output)
Ground/Shield Pin 1
Data ( - ) signal Pin 2
Data ( + ) signal Pin 3
Do not use
Do not use
5 Pin Male (Input)
Pin 1
Pin 2
Pin 3
Do not use
Do not use
13
POWER IN DMX IN MENU ENTER

Mechanical Specification

586.93
492.91
DOWN UP DMX OUT POWER OUT