Table of Contents
Advertisement
Features
Mounting
● Light Source: 360pcs white led,192pcs RGB 5050 1W LED
When installing the unit, the trussing or area of installation must be able to
hold 10 times the weight without any deformation. When installing the unit
● Beam angle: 90°
must be secured with a secondary safety attach-ment, e.g. and appropriate
● Power consumption: 300W
safety cable. Never stand directly below the unit when mounting, removing,
● Voltage: AC 110-230V 50/ 60Hz
or servicing the unit.
● Run mode: DMX 512 /Master Slave /Auto Run
Overhead mounting requires extensive experience, including calculat-ing
● DMX channels: 3, 10, 22, 36, 50 & 92 CH
working load limits, installation material being used, and perodic safety
● Built-in Effect: color mixing, variable color chasing, strobing and fading
inspection of all installation material and unit. If you lack these qualifcations,
● Fan controlled by PWM waves
do not attempt the installation yourself.
● 4 dimmer curves
The installaiton should be checked by a skilled person once a year.
● TFT displayer with four buttons
● Material: Aluminum body
● IP65
● Temperature: -20°C～40°C
● Dimension:1017×140×147mm
● N.W: 6 KG
● G.W: 8 KG
Accessory
① 1/4 turn fast lock x 2
② Power cable x 1
①
The ARC BAR PRO STROBE is fully operational in three different mounting
positions, hanging upside-down from a ceiling, set on a flat level surface or
mount the unit on its side. Be sure this fxture is kept at least 0.5m away from
②
any flammable materials (decoration etc.). And you'd better use and install
the supplied safety cable as a safety measure to prevent accidental damage
and/or injury in the event the clamp fails (see next page).
User manual
③
④
③ DMX cable x1
④ User manual x 1
20
4
Advertisement
Table of Contents
