Iridium Arc Bar Pro 1215 Manual page 4

INFORMATION-In this menu, you can learn about the information of RDM, software and
hardware of the light.
1.Press "ENTER" and then press "UP" or "DOWN" to "INFORMATION".
Packaging: Thanks for your purchasing the ARC BAR PRO STROBE. All the lights have
2.Press "ENTER" and you can see 3 items as below:
1) RDM - It shows RDM information.
been checked and are in excellent operating condition. Please check the shipping carton
2) Hardware - It shows the Hardware information.
first. Because there maybe damage occurred during the shipment. Then check the lights
3) Software - It shows the Software information.
carefully and be sure that the light is intact and works normally. In the event damage has
been found, spare parts are missing or the lights works abnormally, please contact us for
FACTORY RESET-In this menu, you can reset all the value of the system.
1. Press "ENTER" and then press "UP" or "DOWN" to "FACTORY RESET".
further instructions. And please don't return the light to the dealer before contacting us.
2. Press "ENTER" to reset all the values of the system.
Introduction:The ARC BAR PRO STROBE has four operating modes: DMX mode, Auto
mode, Master/Slave and Sound mode. And the light has seven DMX channel. DMX
channel is including 3 channel, 10 channel, 22 channel, 36 channel, 50 channel and 92
channel. You can see 13 kinds of shows when you open the Auto mode .All then all the
lights in Master/Slave mode will run following the one in Auto mode. Using fog or special
effect smoke, you can see better showing effect.
Warning!
1. For the sake of preventing the risk of electrical shock or fire.
2.Don't look directly at the opening lights all the time, or it may damage your eyes.
3
19