Options - Whirlpool WTW6700T Use And Care Manual

Wash-Rinse Temp
Select a water temperature based on the type of load you are
washing. Use the warmest wash water safe for fabrics. Follow
garment label instructions.
Warm rinses leave the loads drier and more comfortable to
handle than cold rinses. However, warm rinses also increase
wrinkling. Cold rinses may help with wrinkling and save energy.
Temperature Guide
Wash Water Temperature
Hot
Warm
Cold
NOTE: In wash water temperatures colder than 60°F (15.6°C),
detergents do not dissolve well. Soils may be difficult to remove.
Care Control Temperature Management
Care Control Temperature Management electronically senses and
maintains a uniform wash and rinse water temperature. Care
Control regulates incoming hot and cold water and is
automatically turned on when a cycle is selected. (See "Preset
Cycle Settings" in "Cycles.")
Care Control is available with Warm/Warm, Warm/Cold and Cold/
Cold settings. The water temperature in the Hot/Cold and Tap
Cold/Cold settings depends on the water temperature at the
water inlet faucets.
Care Control ensures consistent cleaning.
The Hot and Warm setting on this washer will be cooler than
you are accustomed to. Wash temperatures in this ENERGY
STAR ® qualified washer are lower than temperatures you may
be used to in conventional washers. Heated water consumes
the largest amount of energy that a washer uses.
Today's detergents work well at temperatures above 60°F
(15.6°C).
16
Suggested Fabrics
Whites and pastels
Bright colors
Colors that bleed or fade
Delay Wash
You can use the Delay Wash feature to delay the start of a wash
cycle for up to 10 hours (depending on your model).
1. Load the washer and fill the dispensers.
2. Close the washer lid.
3. Press POWER.
4. Select the desired Cycle, Modifiers and Options.
5. Press DELAY WASH. 1H (one hour) will be displayed in the
time display window. The indicator light for Delay Wash will
glow.
6. For a longer delay time, press DELAY WASH. The Start time
will increase by 1-hour steps.
7. Press START. The countdown in hours to the wash cycle will
show in the time display window and the indicator light will
begin to flash.
NOTE: The Start indicator light will not flash when Delay
Wash is chosen. You must press Start to initiate a countdown
for the cycle to begin.
To change the Delay Wash time:
Press PAUSE/CANCEL.
Press DELAY WASH to select the desired delay time.
Press START to begin the countdown.
To cancel Delay Wash:
Press START again to begin the cycle right away or press
PAUSE/CANCEL twice.

Options

Use these pads to select the desired options for your wash cycle.