Operating Controls; Normal Sounds - Whirlpool Cabrio WTW6400S Use & Care Manual

Cycle Deep Clean
(Adds time to the wash cycle)
Whitest Whites Option
Heavy Duty Default
Bulky Items Not available
Sheets/Towels Not available
Normal Option
Casual/Perm Press Option
Colors/Darks Option
Quick Wash Option
Wool Not available
Delicate/Handwash Option
Soak Not available
Rinse & Spin Not available
Drain & Spin Not available
Clean Washer Not available
Extra Rinse
An extra rinse can be used to aid in the removal of detergent or
bleach residue from garments. This option provides an additional
rinse with the same water temperature as the first rinse. This is
the default rinse setting for the Whitest Whites cycle.
Presoak
Use this option for set-in stains and soil that need extra time for
removal. Soaking in this washer is different than in a conventional
washer. The washer sprays the load with water and detergent for
4 minutes at extra-low spin speed followed by a brief period of
wash action at the speed of the selected cycle. Then another
4 minutes of spraying and extra-low spinning occurs. The wash
action then pauses for the detergent to work on the soils. The
Presoak feature is followed by the selected cycle. Using Presoak
will extend your wash cycle.
End of Cycle Signal Volume
The End of Cycle Signal produces an audible sound when the
wash cycle is finished. This signal is helpful when you are
removing items from the washer as soon as it stops. Select Loud,
Soft or Off.

Operating Controls

Power
Press POWER to turn the washer on or off.
Start
Press START to start your washer after a cycle has been
selected. Be sure all desired Modifiers and Options have been
selected. The lid must be closed for the washer to start.
Pause/Cancel
Press PAUSE/CANCEL once to pause or stop the washer at any
time. Press PAUSE/CANCEL once to unlock the lid and add a
garment. Press START to complete the cycle from where it was
stopped. Press PAUSE/CANCEL twice to stop the wash cycle.
The washer will then drain and turn off.
Lid Lock
When the Lid Lock status light glows, the washer lid is locked.
NOTE: You must wait until the Lid Lock Light turns off before the
lid can be opened.

Normal Sounds

Your new washer may make sounds your old one didn't. Because
the sounds might be unfamiliar, you may be concerned about
them. These sounds are normal.
During washing
If you select the Deep Clean option, you will hear a spin/spray
noise at the start of the cycle.
During drain
If water is drained quickly from your washer (depending on your
installation), you may hear air being pulled through the pump
during the end of draining.
During wash and spin
This washer does not have a transmission. The motor provides
direct drive for agitation and spin. You will hear sounds that are
different from those of a conventional washer.
17