Table of Contents
Advertisement
For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call DELTA
Service at (toll free) 1-800-223-7278.
FAILURE TO START
If your machine fails to start, check to make sure the prongs on the cord plug are making good contact in the receptacle, and check
reset button on GFCI - Ground Fault Circuit Interrupt
line.
Problem
Saw will not start
Saw makes poor cuts
Blade not getting up to speed
Machine has excessive vibration
Miter cuts are not accurate
Material binding in the blade
A complete line of accessories is available from your DELTA
Centers. Please visit our Web Site www.deltamachinery.com for an on-line catalog or for the name or your nearest supplier.
Since accessories other than those offered by DELTA
such accessories could be
with this
product.
TROUBLESHOOTING
(If applicable).
Possible Cause
1. Saw un-plugged.
2. Fuse blown or circuit breaker tripped.
3. Damaged power cord.
4. Worn out brushes.
1. Dull saw blade.
2. Blade not mounted properly.
3. Residue on pitch or blade.
4. Incorrect type of blade installed.
1. Extension cord too small gauge or too long.
2. Low current rating from the source.
1. Saw is not mounted securely to stand or
workbench.
2. Miter saw stand or workbench on uneven
floor.
3. Damaged saw blade.
1. Miter scale not reading correctly.
2. Blade is not square to fence.
3. Blade is not perpendicular to table.
4. Workpiece could be moving during
operation.
1. Material could be bowed or could be cutting
through knots.
ACCESSORIES
®
hazardous.
For safest operation, only DELTA
Also, check for blown fuses or open circuit breakers in your power
Supplier, DELTA
Factory Service Centers, and DELTA
®
have not been tested with this product, use of
®
recommended accessories should be used
®
32
Solution
1. Make sure the saw is plugged in.
2. Replace fuse or reset circuit breaker.
3. Contact local authorized Service Center to
have cord replaced.
4. Contact local authorized Service Center
to have brushes replaced if you cannot
replace them yourself. Refer to page 31.
1. Replace blade. Refer to page 14.
2. Correct blade fitment. Refer to page 14.
3. Remove and clean the blade.
4. Change the blade. Refer to page 14.
1. Replace with correct extension cord size.
Refer to page 10.
2. Contact your electric company.
1. Tighten all mounting hardware. Refer to
page 21.
2. Reposition on level surface. Refer to
page 21.
3. Replace blade. Refer to page 14.
1. Check and adjust. Refer to page 16.
2. Check and adjust. Refer to page 16.
3. Check and adjust. Refer to page 15.
4. Clamp workpiece securely to fence.
1. Refer to page 22.
Authorized Service
®
Customer
®
Advertisement
Table of Contents
