Handover Of The System To The User; Disassembly And Disposal - Olsberg EPANA 6 kW Installation Instructions Manual

Installation instructions
EN
for the specialist company
Fig. 2.12 Pour pellets in manually if the pellet duct is empty
Fig. 2.13 Set main switch to "I"
We reserve the right to make technical changes
● Set the master switch to "I" (back right of the appliance)!
ū The touch control panel display is activated automatically.
Note: the smell which may occur as a result of curing of the
protective coating will disappear once the pellet fireplace has
been burning with good room ventilation for several hours at
maximum power.
Attention! Property damage! The pellet fireplace is coated
with a high-quality temperature-resistant coating which only
reaches its final strength after being heated for the first time.
You therefore should not place anything on the tiled pellet
fireplace or touch the surfaces as this may damage the
coating.

2.11 Handover of the system to the user

● After installation, instruct the user of the system with regard to:
ū Use,
ū Operation,
ū Functioning,
ū Care and cleaning (user),
ū Necessary annual maintenance (specialist company)!
● In particular, instruct the user of the system in the risks associated
with the pellet fireplace, as well as in the safety information and
safety precautions!
● Hand the product/the system over to the user together with this
manual and all other documents!
Commissioning certificate
The proper installation, commissioning and handover of the pellet
fireplace is documented by the commissioning certificate (dernières
pages). Instruction of the system user by the specialist company, in
particular in the risks associated with the pellet fireplace and in the
safety information and safety precautions is also certified by the
specialist company and user's signatures.

2.12 Disassembly and disposal

The applicable international, national and region-specific laws and
regulations at the time of disposal of the pellet fireplace must be
observed.
● Take care to ensure that the recyclability of materials, and the
possibility of disassembly and separation of materials and as-
semblies is taken into consideration as well as the environmen-
tal and health risks of recycling and disposal. Material groups such
as plastics and metals of different types should be sorted before
being sent for recycling or disposal!
● The disposal and recycling of electrical and electronic compo-
nents must be done in accordance with the appropriate laws and
country-specific regulations!
EPANA 6 kW
41