Whirlpool WFG114SV Installation Instructions Manual page 13

To Convert Surface Burners
1. Remove burner grate, burner caps and burners.
A. Burner cap
B. Burner
2. Locate LP gas orifice spuds for top burners in the literature
bag included with the range. Three LP gas spuds are
stamped "88" and one "96."
3. Remove Natural gas orifice spuds using a 7 mm combination
wrench.
4. Install LP gas orifice spuds using a 7 mm combination
wrench.
A. Spud
B. Holder
NOTE: Depending on model, the range cooktop may be
equipped with 4 standard burners or 3 standard burners and
1 power burner. Spud size and location remain the same.
For models with 4 standard burners:
Std burner 88
Std burner 88
A
B
A
B
Std burner 88
Std burner 88
For models with 3 standard burners and 1 power burner:
Std burner 88
Power burner 96
5. Place the Natural gas orifice spuds in the parts bag for future
use and keep with the bag containing literature.
6. Reinstall burners, burner caps and burner grates.
To Convert Oven Burner
1. Open the oven door and remove oven racks, oven tray, flame
spreader and set aside.
2. Lift oven burner. The orifice spud is behind the oven burner
air shutter.
3. Locate LP gas orifice spud stamped "56" in the bag
containing literature supplied with the range.
A
A. Air shutter
4. Use a " combination wrench and remove the Natural gas
orifice spud.
5. Install the number "56" LP gas spud.
IMPORTANT: Do not overtighten.
A
A. LP oven orifice spud stamped with "56"
6. Place Natural gas oven burner spud in plastic parts bag along
with Natural gas cooktop burner spuds for future use and
keep with the bag containing literature.
7. Reinstall oven burner.
8. Reinstall oven racks, oven tray and flame spreader.
Std burner 88
Std burner 88
B
13