Whirlpool SF114PXS Product Dimensions

®
30" Freestanding Gas Range
PRODUCT MODEL NUMBERS
SF114PXS WFG114SW
WFG114SV
Gas supply: Use " rigid pipe gas supply line to
the range location. A smaller size pipe on long
runs may result in insufficient gas supply. With
L.P. gas, piping or tubing size can be
minimum. If local codes permit, it is
recommended that new flexible metal tubing,
design-certified by CSA, " or
connecting the range to the rigid gas supply line. A
" male pipe thread is needed for connection to
pressure regulator female pipe threads. An
individual manual shutoff valve must be located in
the same room, but external to the range.
Electrical: A 120-volt, 60 Hz, AC-only, 15 amp,
electrical supply fused on both sides of the line. A
separate circuit is recommended. A time-delay
fuse or circuit breaker is recommended.
CABINET OPENING DIMENSIONS
18" (45.7 cm) min.
clearance upper
side cabinet to
countertop
This shaded area
recommended for
electrical outlet.
Contact a qualified floor covering
installer to check that the floor
covering can withstand at least 200°F.
Use an insulated pad or " (6.4 mm)
plywood under range if installing
range over carpeting.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
OVERALL DIMENSIONS
"
" I.D., be used for
depth with handle
13" (33.0 cm)
30" (76.2 cm) min.
cabinet opening
width
30 " (76.5 cm)
opening width
2" (5.1 cm) min.
countertop space to
side wall or other
combustible material
24"
(61 cm)
5"
3"
(12.7 cm)
(7.6 cm)
26 " (67.9 cm)
24 " (61.6 cm)
max. upper
cabinet depth
This shaded area
recommended
for installation of
gas pipe.
10"
(25.4 cm)
8"
(20.3 cm)
5"
2"
(12.7 cm)
(5.1 cm)
*** NOTE: 24" (61.0 cm) min. when bottom of wood or metal cabinet is
protected by not less than " (6.4 mm) flame retardant millboard
covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm)
stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm)
copper.
30" (76.2 cm) min. clearance between the top of the cooking
platform and the bottom of an unprotected wood or metal cabinet.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
29 " (75.9 cm)
width
For minimum clearance
to top of cooktop, see
NOTE.***
Do Not seal the range to
the side cabinets.
If cabinet depth is greater
than 24" (61.0 cm), oven
frame must extend
beyond cabinet fronts by
" (1. 3 cm) min.
36"
(91.4 cm)
cooktop
height
46 " (117.5 cm)
overall height for
tall backguard
models
Ref. W10032050B
9/22/10