Yamaha YSP-800 Owner's Manual page 82

Press _ / _ to switch between PRESET:
RESET and PRESET: CANCEL.
+
rOE
i.-.'i.e'i.-. ".-..i.- , "J i.e'i.-. ".-.i.- ,
$
VOL
i..."i.e"i... "....i.- i "J i £.H"J I i... i
• Select PRESET: RESET to reset all of the current
settings.
• Select PRESET: CANCEL to cancel the resetting
procedure.
5 Press STANDBY/ON on the front panel or on
the remote control to set this unit to the
standby mode.
s_ or @._
Front panel Remote control
The new setting will be activated when you turn on
the power of this unit next time.
You can adjust the sonnd beam output level of each
speaker by using the test tone or the audio output being
played back in each bean] mode to achieve a more true-to-
life surround sound experience.
• All the speaker levels cannot be a_[justed when the stere() mode
is selected as the beam mode (see page 42).
• FRONT L/R cannot be adjusted whet] the stere() plus 3 mode is
selected as the beam mode (see page 41).
• Only CENTER cat] be a([justed whet] the target mode is
selected as the beam mode (see page 43).
-#:
If the level of a particular speaker cannot be adjusted, _:IB
appears it] the front panel display,
• Using the test tone
You can use the test tone feature to output a test tone from
each speaker to manually balance the speaker levels.
Use the test tone to set speaker levels so that the volume
level of each speaker is identical when heard from your
listening position.
Press TEST on the remote control.
TEST LEFT appears in the front panel display and a
test tone is output fro]]] the front left speaker.
TEST
+
rOE
*1...'.-. " ] t.-t.- "
E
78