Yamaha YSP-800 Owner's Manual page 26

®
'i'i'i il
....
The remote control transmits a directional infrared beam.
Use the remote control within 6 m of this unit and point it
toward the remote control sensor on this unit during
operation.
Press and hold the _ mark on the battery
cover and then slide off the cover.
Insert the two supplied batteries (AA, R6,
UM-3) into the battery compartment.
Make sure you insert tile batteries according to tile
polarity markings (+/).
3 CIosethe battery cover.
• Change all of the batteries if you notice the following
conditions: the operation range uf the rmnote contrul decreases.
the indicator does nut blink or its light becumes dim.
• Do not use old batteries together with new ones.
• Do not use different types uf batteries (such as alkaline and
manganese batteries) together. Read the packaging carelully as
these dilTerent types of batteries may have the same shape and
cu]or.
• Exhausted batteries may leak. If the batteries hme leaked,
dispose of them in)mediately. Avoid touching the leaked
material ur letting it come into contact with clothing, etc. Clean
the battery compartment thoroughly belore installing new
batteries.
• Do nut throw away batteries with general house waste. Dispuse
of them correctly in accurdance with your local regulations.
• The contents uf the memury stored in the remote cuntrol may be
erased in the folluwing cases:
The remote control is lelt without batteries lor more that) 2
minutes.
Exhausted batteries remain in the remote controh
The buttons on the remote contrul are acckleutally pressed
when you change batteries.
• If the mmnory stored in the rmnote cuntrol is unwantedly
erased, insert
uew
batteries and reset the rmnote CUlltru]codes
again.
• Du not spill water or other liquids on the remote controh
• Du not drop the remute controh
• Do not leave or store the remote control in the lbllowing types
of conditions:
places uf high humidity, such as near a bath
places of high temperatures, such as near a heater or a stove
places of extremely low temperatures
dusty places
• Do not expose the remote control sensor on this unit to direct
sunlight or lighting such as i)werted fluorescent lamps.
• If the batteries grow old, the effective operation distance of the
remote control decreases considerably. If this happens, replace
the batteries with twu new ones as suon as possible.
22