Outdoor Unit Location Selection - LG LGRED LH188HHV1 Installation Manual

Single-zone convertible mid-static ducted lgred system

Table of Contents

Planning for Snow and Ice, continued.

CAUTION

When deciding on a location to place the outdoor unit, be sure to choose an area where run-off from defrost cycle will not accumulate and freeze on

sidewalks or driveways, which will create unsafe conditions. Properly install and insulate any drain hoses to prevent the hose from freezing, cracking,

leaking, and causing unsafe conditions from frozen condensate.

NOTE

Choose an area where run-off water from defrost cycle will not accumulate and freeze on sidewalks or driveways. Properly install and insulate any

drain hoses to prevent the hose from freezing, cracking, leaking, and damaging the outdoor unit.

The indoor unit will take longer to provide heat, or heating performance will be reduced in winter if the unit is installed:

1. In a narrow, shady location.

2. Near a location that has a lot of ground moisture.

Tie-Downs and Lightning Protection

Tie-Downs

• The strength of the roof must be checked before installing the

outdoor units.

• If the installation site is prone to high winds or earthquakes, when

installing on the wall or roof, securely anchor the mounting base

using a field-provided tie-down configuration approved by a local

professional engineer.

• The overall tie-down configuration must be approved by a local

professional engineer.

Always refer to local code when using a wind restraint system.

Lightning Protection

• To protect the outdoor unit from lightning, it must be placed within

the specified lightning safety zone.

Table 7:

Building Height (feet)

• Power cable and communication cable must be installed five (5) feet away from lightning rod.

• A high-resistance ground system must be included to protect against induced lightning or indirect strike.

NOTE

If the building does not include lightning protection, the outdoor unit will be damaged from a lightning strike. Inform the customer of this possibility in

advance.

GENERAL INSTALLATION GUIDELINES

148

197

Due to our policy of continuous product innovation, some specifications may change without notification.