Table of Contents
Advertisement
[e] SIDE FRAME
[e] SIDE FRAME
Remove the Sliding Door, Side Cover and Top Cover. Unbind the wiring on the Side Frame.
Remove the Sliding Door, Side Cover and Top Cover. Unbind the wiring on the Side Frame.
Remove the two screws securing the Top Frame and the top of the Side Frame. Lift the Side
Remove the two screws securing the Top Frame and the top of the Side Frame. Lift the Side
Frame off the bottom fit.
Frame off the bottom fit.
[f] CENTER FRAME (Except HNC-120 type)
[f] CENTER FRAME (Except HNC-120 type)
Remove the two flat head machine screws
Remove the two flat head machine screws
(black) securing the Center Frame to the rear
(black) securing the Center Frame to the rear
and the two machine screws securing the Center
and the two machine screws securing the Center
Frame to the Top Frame. Tilt the Center Frame
Frame to the Top Frame. Tilt the Center Frame
and release it from the fit.
and release it from the fit.
[g] HOLDER - EVAPORATOR PIPE
[g] HOLDER - EVAPORATOR PIPE
Remove the truss head tapping screw (4 x 25)
Remove the truss head tapping screw (4 x 25)
from the bottom. Take off the Center Frame. Be
from the bottom. Take off the Center Frame. Be
careful with the Evaporator Pipe. It will be
careful with the Evaporator Pipe. It will be
released and hang down. Remove the truss
released and hang down. Remove the truss
head tapping screw (4 x 10) from the bottom.
head tapping screw (4 x 10) from the bottom.
[h] CONTROL BOX
[h] CONTROL BOX
Remove the two machine screws indicated. Pull
Remove the two machine screws indicated. Pull
out the Control Box.
out the Control Box.
74NL5870112
74NL5870112
Holder -
Holder -
Evaporator Pipe
Evaporator Pipe
Evaporator Pipe
Evaporator Pipe
Truss Head Tapping
Truss Head Tapping
Screw 4 x 10
Screw 4 x 10
19
19
Fig. 3
Fig. 3
Truss Head Tapping
Truss Head Tapping
Screw 4 x 5
Screw 4 x 5
Fig. 4
Fig. 4
Fig. 5
Fig. 5
Advertisement
Table of Contents
