Table of Contents
Advertisement
DANGER!
BEFORE REPLACEMENT OF GOBOS/COLOR FILTERS,A PROJECTOR MUST BE OFFTHE POWER!
5. SETUPAND CONFIGURATION
●FRONT PANELOPERATION
To browse through or change a projector's settings, open the small cover in the head and a LCD control panel appears as the
figure shown above. Launch the projector and press button ENTER for more than 3 seconds to unlock the panel after power on. Then
press UP or DOWN button for menus desired. Each main menu has its own sub-menus. And each menu is for a special
function. For more details, please refer to Operation Menu in section five.
1.
At the page for setup of functions, press UP or DOWN button for functions desired;
2.
While setting up menus, press ENTER button to save the changes or enter into submenus; press UP or DOWN
buttons to change values( increase or decrease values)
Press button ESCAPE button, it will return to the upper menu. If the button not pressed, the system will go back to initial display
status.
DMX STARTADDRESS
●
Each unit must be given a DMX start address so that the correct projector responds to the correct control signals. This DMX start address
is the channel number from which the projector starts to "listen" to the digital control information being sent out from the controller. The
unit has 3 DMX modes. There are standard mode ,short mode and extended mode. For example standard mode has 30 channels, so set
the No. 1 projector's address 001, No. 2 projector's address 031, No. 3 projector's address 061, No. 4 projector's address 91, and so on.
Launch the projector. Press button ENTER more than 3 seconds to unlock panel.
Press button ENTER to display DMX address;
Press button UP or DOWN, the DMX address can be set;
Press button ENTER to confirm to save the address automatically.After powered on next time, the default will be last value saved
Press button ESCAPE, it will return to the upper menu.
STAND-ALONE MODE
●
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within 512.
●MASTER/SLAVE MODE
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture's DMX output to the second fixture's DMX input using XLR-XLR control cable and then connect the second
Escape
Enter
8
Up
Down
Advertisement
Table of Contents
